910084-M
Trak Kut II Saw
Phone: (262) 637-9681
Email:
custserv@racinerailroad.com
www.racinerailroad.com
10.2018 Rev 1
Page 14
Section 2: Maintenance
Maintenance
Do not
perform maintenance on the Trak Kut II while the engine is
running
Make sure that the following safety devices are installed on the Trak Kut II saw:
•
The fuel tank cap is properly installed.
•
The rail clamp is secure.
•
The rail saw blade is installed properly.
Fueling and Lubrication
At a minimum, perform the following routine daily maintenance on the Trak Kut II saw to keep it in good
working condition.
Do not
perform maintenance on the Trak Kut II while the engine is
running.
Fill fuel tank outdoors or in a well-ventilated area, away from sparks,
open flames, pilot lights, heat and other ignition sources. If fuel spills,
wait until it evaporates before starting the engine.
Turn the engine OFF and let it cool at least two minutes before
removing the gas cap. Replace the gas cap before starting.
Do not use gasoline that contains methanol.
Some fuels, called
oxygenated or reformulated gasoline, are gasoline blended with
alcohols or ethers. Excessive amounts of these blends can damage the
fuel system or cause performance problems.
If any undesirable operating symptoms occur, use gasoline with a lower
percentage of alcohol or ether.
Grease Type and Locations
Permanently sealed bearing and self-lubricating bushings are used extensively on the Trak Kut II saw
to reduce daily maintenance. Make sure that all bearings and moving parts are properly lubricated.
Engine fuel type and location
The engine mounted fuel tank holds 2.18 US pints. Use clean, fresh regular unleaded gasoline with a
minimum of 90 octane.
Fresh fuel prevents gum from forming in the fuel system or the essential carburetor parts. Purchase
fuel in quantity that can be used within 30 days.