Fig. 15 Fig. 16 Fig. 17
ADJUST THE TIGHTNESS OF CLUTCH CABLE
Tighten the screw of the clutch cable by hand (Fig. 18), and screw M8 nut to the position of small
iron block to check whether the clutch cable is properly tightened. The clutch cable should be
tightened if the blade does not rotate or slips when the rotary tiller is loosening the soil. Then tighten
the two M8 nuts with a wrench (Fig. 19).
Fig. 18 Fig. 19
INSTALL THE THROTTLE SWITCH
Install the throttle switch
in the φ6.3 hole in the right handrail
(Fig. 20), insert M6*45 bolts into the corresponding holes of the
throttle switch and the right handrail (Fig. 20), and then tighten
the M6 cap nut with a wrench (Fig. 20).
Fig. 20
Bolt M6*45
Throttle switch
