Caution: In the interests of safety the tubes should not be dismantled after they have been
assembled.
-
Attach the collect bag to the hook on upper tube and the outlet on the bottom of motor
housing.
4. OPERATION
Before starting the machine, make sure that collect bag is fitted and the shoulder harness is
adjusted to a suitable working position.
a. Extension cable
The tool must be connected to an extension cable. Plug the cable of the tool into extension
cable. Then, attach the extension to the cable holder to hold it.
The extension cable shall not be lighter than the standardised code H05 RN-F/H05 VV-F. See
your retailer or manufacturer for more advice.
b. Switching on and off the tool
Before start the tool, be sure that the speed control knob is on the position 1 (lower position).
-
To switch on, press the ON/OFF switch (fig 2a).
-
To stop the tool, release the ON/OFF switch (fig 2b).
2a
2b
c. Speed Control
You can adjust the power of the air flow with the control knob. The power goes to 1 to 6 (from
the lower to the highest power).
Turn the knob to adjust the power of the airflow, according the work performed.
When stop to use the machine, put the knob to the position 1.
16
