PROBLEM
LIKELY CAUSE
SOLUTION
1. The Starter motor runs but
–faulty fuel supply
–check the level in the tank (
☛
5.3.3)
the engine does not start
–check the wiring of the fuel open command
–check fuel filter
–faulty ignition
–check that spark plug caps are firmly fitted
–check that the electrodes are clean and have
the correct gap
2. The engine stops
–earth connections of the micros witches
–check connections
disconnected
–engine badly earthed
–check engine earth connection
3.
The engine does not start
– earth connections of the micros witches
–check connections
disconnected
– you are not ready for starting
–check that the conditions allowing the
start are met (
☛
5.2.a)
4. The engine stops
–earth connections of the micro switches
–check connections
disconnected
5.
Starting is difficult or the engine
–fault in carburetion
–clean or replace the air filter engine runs
erratically
–flush out the float chamber
–empty fuel tank and refill with fresh fuel
–check and, if necessary, replace fuel filter
6.
Weak engine performance
–forward speed too high in relation to
–reduce the forward speed and/or raise
during cutting
cutting height
the cutting deck (
☛
5.4.5)
7.
Engine stops when blade is engaged
–you are not ready to engage the blade
–check that the safety
requirements are met(5.2.b)
8.
Unusual vibrations while working
–blade unbalanced
–Contact your dealer
–blade loose
–Contact your dealer
–fixing bolts loose
–check and tighten all the fixing bolts
of the engine and frame
9. Uncertain or ineffective braking
–the brake is not adjusted correctly
–Contact your Dealer
10.
Uncertain or ineffective braking
–the brake is not adjusted correctly
–Contact your Dealer
30
Summary of Contents for RAC62PRRS
Page 11: ...3 6 FITTING THE DEFLECTOR 11...
