Screw on the tank cap firmly after filling.
Wipe down the machine if you have spilled fuel.
Move at least 10m away from where you filled the fuel tank before starting the engine.
Never attempt to burn spilled fuel.
When replacing, use only replacement parts and accessories recommended by the manufacturer. Failure
to do so could reduce the efficiency of your machine and put you at risk of injury.
Maintain your machine with care, according to the instructions in the "Maintenance" section of this manual.
Check the condition of your machine before each use. Make sure that the fasteners are tight, that there
are no fuel leaks and that no parts are damaged.
Replace any damaged part.
To reduce the risk of injury from contact with moving parts, stop the engine before installing or removing
accessories.
Do not use your machine if the protective elements are not installed. Always remove the spark plug before
carrying out any maintenance or working on any moving part.
Do not point the blower nozzle at people or pets.
Never start this machine if the required accessories are not installed.
Do not operate the machine near open windows,
Use a rake and broom to loosen debris before blowing.
Lightly dampen surfaces in dusty conditions before working.
Use the pipes fully assembled so that the air flow can reach the floor.
Caution: there is a risk of danger from rotating parts. Avoid coming into contact with them.
In case of blockage or breakdown, stop using the machine immediately. Inspect it and remove the
blockage securely (see chapter “Maintenance”). In the event of a fault, please take your machine to a
qualified service for inspection.
Fuel handling
Be very careful when handling fuels. They are flammable and the vapors are explosive.
Use only an approved container.
Never remove the fuel cap or add fuel while the machine is on. Turn off the unit and allow the engine and
exhaust components to cool before refuelling.
Do not smoke.
Never refuel inside a room
Never store the tool and the fuel tray indoors where there is a naked flame, such as near a water heater.
If fuel has spilled, do not attempt to start the machine, but rather move it away from the spill before starting
to use it. Clean any spills.
Replace and tighten the fuel tank cap after refuelling.
Follow the instructions in this manual for filling the tool with fuel.
Maintenance and storage
When the machine is stopped for servicing, inspection, or storage, or to change an accessory, shut off the
power source and make sure that all moving parts have come to a complete stop. Allow the machine to cool
before making any inspections, adjustments, etc. Maintain the machine with care and keep it clean.
Store the machine in a dry place out of the reach of children.
Always allow the machine to cool before storing.
Replace worn or damaged parts for safety. Use only genuine replacement parts and accessories.
Never attempt to override the interlocked feature of the guard.
Residuals risks
Even if you use this product in compliance with all safety requirements, potential risks of injury and damage
remain. The following hazards may arise from the structure and design of this product. Always be vigilant
when using this product, so you can recognize and manage the risks early. Rapid intervention can prevent
serious injury and property damage. Turn off the tool if there are any malfunctions. Have it checked by a
qualified professional and have repairs carried out, if necessary, before using it again.
There are harmful health consequences resulting from the emission of vibrations if the product is used for
long periods of time or not properly managed and properly maintained.
There is risk of injury and property damage due to attachments or broken the sudden impact of hidden
objects.
Risk of injury to persons and property caused by flying objects
Inhalation of gasoline particles or toxic gases.
Contact with moving parts. (Ex: Danger related to the starter handle (Risk of kickback))
Hearing loss if hearing protection is not worn.
