ORIGINAL INSTRUCTIONS
▪When the battery is outside the drill, cover the contacts
to avoid short circuits (e.g. from tools)
▪Do not throw batteries into water or fire, risk of
explosion!
▪Protect the battery from impacts, and don't open it.
▪Never discharge the battery completely and recharge
occasionally if not used for a prolonged period
WARNING: Do not recharge non-rechargeable
batteries.
7.2 Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the tool’s construction and design:
▪Damage to lungs if an effective dust mask is not worn.
▪Damage to hearing if effective hearing protection is not worn.
▪Health defects resulting from vibration emission if the power tool is being used over longer period of time or not
adequately managed and properly maintained.
WARNING! This machine produces an electromagnetic field during operation. This field may under some
circumstances interfere with active or passive medical implants. To reduce the risk of serious or fatal injury,
we recommend persons with medical implants to consult their physician and the medical implant manufacturer
before operating this machine.
8. OPERATION
8.1 Charging the battery
The battery (5) must be charged before first use. Only after several charge and discharge cycles the battery will attain
full capacity.
Only use the provided adaptor (10) to charge the battery set.
Only charge the battery set when the ambient temperature is within 10° - 40 °C.
Plug the adaptor (10) to a 230 V alternating voltage source.
The battery (5) should under no circumstances be disassembled.
To remove the battery, press the battery release button (6) on the top side of the battery set and extract the battery (5).
Connect the plug of the charger to the loading-socket (9) of the battery-set.
Red LED will light once the battery has been connected to the charger and the charging procedure will proceed.
The battery set is completely loaded and ready for use once the green LED is lit and the red LED is OFF – after
approximately 1 hour(fast charger) or 3-5 hours (slow charger).
8.2 Positioning and removing a drill or screw bit
This tool is equipped with a keyless chuck.
10
