Chapter 4 - Managing and Monitoring
One-Touch Annunciation Configuration Display
59
One-Touch Annunciation Configuration Display
The “One-Touch Annunciation” Configuration Display system is an easily accessible
press-to-touch display of the SES Controller card swtiches 1 through 3 settings, fan control
setting, Host IO card and Disk I/O card speed mode, presence of Disk I/O cards, presence
of Host I/O cards, and presence of RAID Controllers. Host I/O cards and RAID
Controllers are not applicable to the OmniStor 4000F.
By pressing and holding the Alarm Reset button, the Drive Activity LEDs will all be
extinguished and the Drive Status LEDs will illuminate in unique combinations to display
settings and conditions. Below is an illustration and a table that describes the Drive Status
LEDs and their meanings:
Status LED Callouts
Status LED Conditions
RESET ALARM
Rt Host I/O
Card Present
Host I/O Mode
1Gb/2Gb
Lt Host I/O
Card Present
Disk I/O Mode
1Gb/2Gb
Lower CNTRL
Present
Upper Disk I/O
Card Present
Press and Hold
to display settings
Upper CNTRL
Present
Lower Disk I/O
Card Present
Fan Control
Enabled
SES Switch
AD0 Position
SES Switch
AD1 Position
SES Switch
AD2 Position
One-Touch Annunciation Configuration Display
LED On = Up Position
LED Off = Down Position
LED On = Up Position
LED Off = Down Position
LED On = Up Position
LED Off = Down Position
LED On = Auto Control Enabled
LED Off = Disabled
LED On = 2Gb Mode
LED Off = 1Gb Mode
LED On = 2Gb Mode
LED Off = 1Gb Mode
LED On = Present
LED Off = Missing
LED On = Present
LED Off = Missing
LED On = Present
LED Off = Missing
Note: Both Host IO cards must be set to the same mode setting, otherwise the LED will indicate 1Gb mode, this also applies to the Disk I/O cards.
LED On = Present
LED Off = Missing
LED On = Present
LED Off = Missing
LED On = Present
LED Off = Missing
Slot 10
Fan Control
Slot 2
Host I/O Cards 1 Gb/2 Gb Mode
Slot 5
Disk I/O Cards 1 Gb/2 Gb Mode
Slot 8
Upper Disk I/O Card Present
Slot 11
Lower Disk I/O Card Present
Slot 3
Right Host I/O Card Present
Slot 6
Left Host I/O Card Present
Slot 9
Lower Controller Present
Slot 12
Upper Controller Present
Slot 1
SES Switch AD0
Slot 4
SES Switch AD1
Slot 7
SES Switch AD2
Summary of Contents for OMNISTOR 4000f SERIES
