Chapter 4 - Managing and Monitoring
Uploading SES Controller Card Firmware
65
NOTE:
Ensure that the protocol “Xmodem” is selected.
From the Xmodem send screen you can monitor the progress of the upload. You can
safely stop the transfer without affecting your existing firmware any time during the
transfer until it has been completed. The upload does not overwrite the firmware
during the upload process, it writes the new code into unused EEPROM space until
completed, then erases the flash and re-programs the new firmware code to the
EEPROM active region.
If you elect to stop an upload in progress, ensure that the stop (abort) command was
completed by typing <Control-X> at the cursor.
Xmodem Transfer Screen
9
Verify the new firmware has successfully loaded, type <Control-E>.
10
Press the <Esc> key to return to the terminal utility main menu.
Summary of Contents for OMNISTOR 4000f SERIES
