5
3. Hook the Garage Door Control onto the Wall Mounting Bracket (with the Mounting Holes of the Garage Door
Control).
4. Push the Garage Door Control (in the direction as indicated in below picture) to lock it into the mounting bracket.
5. Connect the GDC-3 terminals to the pushbutton wall console terminals on the garage door opener. Either wire can
be connected to either terminal. (The wall console terminals may be named “PWC”, “WC”, “PB”, “PUSHBUTTON”
or “RED” and “WHITE”. Terminal names and locations vary by model.)
6. Plug in the DC 9V 1A output Power Adapter and connect to power supply.
7. Restore power to your garage door opener.
Operation
Remote Operation of Garage Door
After GDC-3 has been included in the Z-Wave network, the Z-Wave controller can remotely open or close the
garage door with Z-Wave command [COMMAND_CLASS_BARRIER_OPERATOR]
and
[BARRIER_OPERATOR_SET], using parameters below:
Open : Target Value = 0xFF
Close : Target Value = 0x00
Before the remotely activated garage door begins to move, the warning LED indicators (Green and Red) will
