Step 1.
Rail Attachment: Attach the Inner Rail to the chassis by aligning the Shoulder
Lugs with the keyholes in the Inner Rail, then slide toward the front of the server.
Install supplied M4 pan head screw as shown to secure inner rail to the chassis.
Right side is shown, Left side is labeled "L". Repeat for the other side
2Post Center Installation Instructions
Step 2.
Attach Rear Brackets: Attach the Rear Brackets to the Outer Rail Assemblies,
using included 8-32 flat head screws and keps nuts. Ensure they are set to the
required "Mounting Depth".
Page 4
Inner Rail
Labeled "R"
Lug
M4 x 6mm Pan
Head Screw
Outer Rail
Rear Bracket
8-32 x.312 Flat Head Screws
8-32 Keps Nuts
4Post Installation Instructions
Step 4.
Install the equipment: Slide the equipment all the way in. Tighten the (2) Pan
Head Screws on the back of the left slide rail. Slide the equipment out about 8
inches and tighten the (2) Pan Head Screws on the front of the left slide rail.
Note:
When tightening the loose rails, support the bottom of the server to ensure proper
rail adjustment.
Summary of Contents for 2Post
Page 6: ...Page 6...
Page 7: ...Page 7...
