3.2.3. Setting Ethernet access parameters
Menu Link > Service access > Services
Those settings are necessary to make new units accessible within target Ethernet network. Typically,
all following parameters should be set according to both networks IP addressing, routing, planned access
methods for data and for management, etc.:
• IPv4 address – enter a valid IP address to access the unit. The default IP address has to be replaced
with a valid address. Keeping the default address will probably lead to future problems in the network.
• Netmask – enter the network mask.
• Gateway – if necessary, enter a gateway, otherwise leave blank.
• Enable access protocols that you will need. For security reasons, do not enable more than is neces-
sary.
• HTTP(S) – allow access to the web interface.
• Telnet – enabling access to the CLI interface using telnet protocol.
• SSH – enabling access to the CLI interface using SSH protocol.
• Management VLAN – Enabling 802.1Q VLAN tag for separation of user and service operations.
• Management VLAN ID – Defining 802.1Q VLAN tag for service operations.
Fig. 3.4: Configuration menu Link settings > Service access > Services
For full explanation of all possibilities of this screen see
Section 5.4.3, “Service access”
in
45
© RACOM s.r.o. – RAy3 Microwave Link
Step-by-step Guide
Summary of Contents for RAy3-11
Page 2: ......
