Link mode Eth1, Eth2
Status of Ethernet interface. Current bit rate:
• 10 = 10BASE-T
• 100 = 100BASE-TX
• 1000 = 1000BASE-T; 1000BASE-SX; 1000BASE-LX
• 2500 = 2.5GBASE-T
• 5000 = 5GBASE-T
• 10000 = 10GBASE-T; 10GBASE-SX; 10GBASE-LX
and state of duplex:
• FD = full duplex
• HD = half duplex
Service access
MAC address
HW address of the Ethernet module.
IPv4 address
IP address in the standard dotted decimal notation, including the bit width of netmask after the for-
ward slash.
Management VLAN
Service access via VLAN management only.
Services
Services enabled for unit management and monitoring (Web, Telnet, SSH, SNMP, NTP).
USB accessories
Indicates physical devices inside USB connector in system slot 'S' and its status, for example:
• n/a - info not available (peer has older fw),
• No device - unplugged,
• (Product) - not a network device,
• WiFi: disabled,
• WiFi: 169.254.170.168 / 28,
• Eth: disabled,
• Eth: 169.254.170.168 / 28
Unit 24S compatibility
(formerly 'Unit S mode') This parameter is available only for newly deployed 24 GHz units without
the 'S' label in Product code (i.e. '24S'). When "active", the unit behaves like the unit '24S' (it can
establish a link only with another '24S' unit). For a link between the units without the 'S' label, this
compatibility needs to be disabled ("off").
Radio link statistics
Statistics Cleared
Time of log clearing.
Statistics Period
Period of log refresh.
Overall Link Uptime
Overall time the link has been connected.
RAy3 Microwave Link – © RACOM s.r.o.
86
Configuration
Summary of Contents for RAy3-11
Page 2: ......
