It is the responsibility of the installer to ensure that all building and safety codes are met and that the
installation is fully completed and equipment properly secured.
1.4. RoHS and WEEE compliance
This product is fully compliant with the European Parlament's 2011/65/EU RoHS
(Restriction of Certain Hazardous Substances in Electrical and Electronic
Equipment) and 2012/19/EU WEEE (Waste Electrical and Electronic Equipment)
environmental directives.
Used equipment must be collected separately, and disposed of properly. Racom
has instigated a programme to manage the reuse, recycling, and recovery of
waste in an environmentally safe manner using processes that comply with the
WEEE Directive.
Battery Disposal - This product may contain a battery. Batteries must be disposed of properly, and may
not be disposed of as unsorted municipal waste within the European Union. See the product document-
ation for specific battery information. Batteries are marked with a symbol, which may include lettering
to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling, return the battery to your
supplier or to a designated collection point.
1.5. Liability for Defects and Safety Instructions
Please read these safety instructions carefully before using the product:
•
Liability for defects does not apply to any product that has been used in a manner that conflicts with
the instructions contained in this operator manual, if the case in which the radio modem is packed
has been opened, or if the equipment has been tampered with.
•
The radio equipment can only be operated on frequencies stipulated by the body authorised by the
radio operation administration in the respective country and cannot exceed the maximum permitted
output power. RACOM is not responsible for products used in an unauthorised way.
•
Equipment mentioned in this operator manual may only be used in accordance with instructions
contained in this manual. Error-free and safe operation of this equipment is only guaranteed if this
equipment is transported, stored, operated and controlled in the proper manner. The same applies
to equipment maintenance.
•
In order to prevent damage to the radio modem and other terminal equipment the supply must always
be disconnected upon connecting or disconnecting the cable to the radio modem data interface. It
is necessary to ensure that connected equipment has been grounded to the same potential.
•
Only the undermentioned manufacturer is entitled to repair any devices.
•
Should the RAy2 unit be used with accessories other than those recommended, Racom takes no
responsibility for any malfunction caused by the use of such accessories. Using unsuitable accessor-
9
© RACOM s.r.o. – RAy3 Microwave Link
Safety, environment, licensing
