Fig. 3.17: Disconnection from the remote RipEX
Access Time Comparison
You can also try to access the remote RipEX unit without using Fast Remote Access feature. When
locally connected to RipEX A, just type RipEX B's IP address (192.168.1.102) into the browser and
wait for the page to load.
You will see a huge impact on the access time. Again, feel free to change the Modulation rate (Settings
tab) or changing the default Bridge mode to the Router mode.
Note
You need to configure routing accordingly if the Router mode is active.
3.6.3. Alarm Management – Fan Kit
The Demo case also contains Fan kit connected to the RipEX A using HW alarm output, see Fig. 3.18,
“Fan kit using Alarm Output”. Generally you can define when RipEX is in the alarm state. E.g. When
the temperature is out of set interval, HW alarm output will be "on" (so the Fan kit can start to operate).
35
© RACOM s.r.o. – RipEX – Radio modem & Router
Demo Case – RipEX & M!DGE
