Tel: +386 3 4900 800
http://radar-electronics.com/
3702003B
Copyright 2016
Page 13
Initial System Power Up and Test
Once the sensor and display are installed, wired, and connected, power
should be applied to test correct system operation. When the system is
operating correctly, the status LED indicating green will be the only light
illuminated. If the detection LED (yellow) is lit, check for any vehicle
obstruction which may be detected by the sensor. If possible, move the
sensor so it is not detecting the object(s). If it is not possible to relocate the
sensor, consult PRECO Electronics
®
.
If for some reason the system is malfunctioning, the status LED and
detection LED will flash in unison and the buzzer will emit a short stuttering
sound. Refer to the Troubleshooting section to determine the error and
potential causes.
Summary of Contents for PreView Side Defender SDR8503
Page 24: ......