67
EN
16.7.2 Menu 9.2 - End point configuration [ ]
1.
First move the blinds
manually to the centre
position.
Setting order
a)
Set the upper end point,
see page 28.
+ -
b)
Set the lower end point,
see page 28.
2.
Select and open
menu
9.2 [ ] End points
.
Additional information about configuring the
end points
The end points must be configured in order for the roller
shutters to stop at the desired upper and lower positions.
It is imperative that both end points are configured, oth-
erwise malfunctions may occur..
Observe the safety instructions for setting the end points
on page 28.
