57
EN
20
(7)
L1
L2
L
N
PE
(13)
22
21
8.2 Connecting the motor cable (13)
1.
Connect the motor cable
(13)
to the connecting
cable supplied by means of a connector and make
the connection according to the following wiring
configuration.
Colour scale for the motor leads (13)
L1
=
(black) *
L2
=
(brown) *
N
= neutral terminal
(blue)
L
= continuous phase (grey)
PE
= earth
(green / yellow)
(7)
= Set button on tubular motor
8.1 Safe cable routing by fixing the plug connection
Connect the motor cable of the RolloTube S-line
Sun DuoFern to the connecting cable supplied
and to the mains or the desired controller (Switch/
button or Troll Comfort etc.).
Fixing the plug connection by clamping to the
retaining spring of a click drive bearing:
The retaining spring
(5)
should be rotated 90° to
be plugged in and re-engaged..
Connecting cable supplied.
The plug connection can be fixed to the drive
bearing if required to secure the cable.
Note about releasing the plug connection
Use an appropriate tool (e.g. a small screwdriver) to
loosen the plug connection.
i
* The actual direction of travel of the
tubular motor and awning depends
on the direction of installation and
the wiring of the tubular motor.
i
Shortening the motor cable
(13)
can
restrict the radio range. The antenna is
also integrated in the motor cable.
