59
EN
5
5
3
5
5
5
5
26
(a)
(b)
(c)
L
N
PE
5
3
(a)
(b)
(c)
(e)
(d)
(f) (g) (h)
(i)
or
25
8.3.4 Parallel connection of several motors
It is possible to connect numerous RADEMACHER
tubular motors in parallel. The number of motors to
be connected in parallel is dependent on the capacity
of the switchgear and circuit-breakers.
The end points must be set at each indi-
vidual motor prior to parallel connection.
Please refer to the respective operating
manual.
i
It is not possible to control individual
motors if the equipment is connected in
parallel.
Parallel connection with Venetian blind
switches or Venetian blind buttons
Up to five motors can be switched in parallel with
RADEMACHER Venetian blind switches or Venetian
blind buttons.
Parallel connection with RADEMACHER
controllers (e.g. Troll Comfort)
Please refer to the technical specifications for the
respective number of tubular motors that can be
connected in parallel.
Installation example
Legend:
(a)
= Junction box
(b)
= Controller, e.g. 1-pole switch / button
(c)
= Mains 230 V / 50 Hz
8.3.3 Controlling the tubular motor using a 1-pole button (closer)
Legend:
(a)
= Set button
(7)
(b)
= 1-pole button
(c)
= Mains 230 V/50 Hz
(d)
= Socket box
Pin assignment
(e)
=
PE
green / yellow
(f)
=
N
blue
(g)
=
L
grey (continuous phase )
(h)
=
black (direction of travel 1)
(i)
=
brown (direction of travel 2)
i
Once the button has been connected
the function must be activated on the
RolloTube S-line Sun DuoFern.
AActivating the ‘1-pole button’ function
1.
Tap the button 4 x briefly and press and hold the
5th time.
2.
The connected tubular motor will acknowledge
this with a slight movement, and the function is
activated.
The switching sequence is as follows:
Extend / Stop / Retract / Stop /...
Deactivating the ‘1-pole button’ function
Repeat the steps 1. and 2.
