62
EN
With the set button on the
tubular motor
OR
With the universal
setting cable
10. Manual adjustment of end points
2.
Extend the awning first.
3.
n addition
press the set button on the tubular motor.
4.
Release the button again as soon as the desired
end point is reached.
5.
You can correct the end point in small steps by
briefly pressing the button.
6.
Switch off the specified direction of travel after
successfully setting the end points.
The respective end point is stored.
Set the switch to the neutral
position and release the set
button.
Direction of
travel 1
press/tap twice briefly
and press and hold
the third time.
Set the rocker switch
to the centre position.
Direction of
travel 2
II
I
III
III
III
II
I
or
1.
First, switch on the mains power or continuous
phase at the universal setting cable.
The LED on
button 3 must
light up
continously.
ON/
SET
ON
7.
Next, switch off the mains power or continuous
phase at the universal setting cable.
OFF
ON/
SET
ATTENTION
A combination of the endpoint adjustment with
a DuoFern radio remote control can cause malfunc-
tions.