64
EN
or
11. Reloading the factory settings
Self-learning mode with a smooth stop is active
again after loading the factory settings.
Notes for carrying out the setting
◆
Either use a new commercially available universal
setting cable
(20)
.
◆
The tubular motor may not be in operation.
Factory settings:
End points:
no end points stored
Self-learning mode:
activated
Blockage detection:
activated
Obstacle detection:
activated
Jog mode using a
1-pole button:
deactivated
Fabric relief and
Fabric tensioning :
activated
When using the universal setting cable (20)
3.
Switch off the mains power supply and reset the
original connection in accordance with the con-
nection diagrams
59 if you have carried out the setting with the
universal setting cable.
1.
Button 3 - ON/SET
First, switch on the continuous phase.
ON/
SET
II
I
III
2.
Button 1
- switch on the desired direction of
travel ( I or II)
> while simultaneously (within one second) press-
ing and holding
Button 2
(set button III), until the tubular motor
confirms this by briefly running up and down (ap-
prox. 5 seconds).
After that the factory settings are loaded.
Subsequently:
◆
Release
Button 2
(set button III)
◆
Button 1
(I/II) in the middle position
◆
Switch off continuous phase -
Button 3
(ON/SET)
+
5 sec.