8
EN
Operation
Manual operation
Manual control, pre-setting of the automatic functions and the basic setting of the
connected sun shading are performed with the buttons on the operating unit.
Up
Stop
Down
The connected awning or Venetian blind can be operated by hand using the buttons ,
and . The arrow buttons have an automatic timer function. Pressing the buttons
briefly (less than 1 second) allows the awning or Venetian blind to be exactly positioned.
If the button is held depressed for longer than 1 second, the drive automatically runs
up to the end position. Pressing stops the drive.
If the rain or wind alarm is active, manual operation is blocked.
Manual/Automatic
The
button switches back and forth between automatic mode (display
)
and manual mode (display ). If the controller is operated manually using the ,
or buttons, it is then in manual mode. The automatic functions are then
deactivated and the awning or Venetian blind is not controlled according to brightness
or temperature. The
button can be used to switch the controller back to automatic
mode (display ).
Pressing the
SET
button briefly calls up the brightness and wind velocity display.
Holding the button depressed calls up the setting mode for the automatic functions and
the basic setting. For further details, see the section “Setting the automatic functions”
or “Basic setting”.
i
