38
EN
Weather station
The weather station should be inspected for soiling twice a year and cleaned, as necessary.
In the event of heavy soiling, the wind sensor may cease to function, display a constant
rain alarm or no longer detect sunshine.
In the event of a power failure, the data input by you is stored for approx. 10 years.
No battery is required for this.
For the sake of safety, the weather station should always be disconnected from
the mains power supply (e.g. switch off or remove the fuse) for cleaning and
maintenance.
Operating unit
Clean the display when necessary using a damp cloth.
Inserting batteries (operating unit)
The battery compartment is inside the housing.
Service / maintenance and care
Open the operating unit by releasing
the catch on the underside of the
housing. Press against the tab using
a flat screwdriver.
Pay attention to the correct polarity of the
batteries. Two commercially available
batteries (1.5 V) or rechargeable
batteries (1.2 V) of type AA (Mignon/
LR6) are required.
Close the housing again by hooking
the front panel with the PCB into the
rear panel from above. The housing
must close with an audible “click”.
i
