RADEMACHER RolloTube CLIS, Translation Of The Original Operating And Assembly Manual

10

EN

7.  Important assembly instructions

Preparation for installation

◆

Check that the voltage / frequency on the type 
plate corresponds to local mains conditions prior 
to installation.

◆

You must remove or deactivate all cables and 
equipment not required for operation of the 
equipment prior to installation of the tubular 
motor.

◆

 Moving drive parts to be operated at a height 
under 2.5 m from the floor must be protected.

◆

 If the tubular motor is to be controlled with a 
switch with a default OFF setting, then the switch 
is to be positioned in the line of sight of the tubular 
motor and at a height of at least 1.5 m.

◆

 The cover of the roller shutter box must be freely 
accessible and removable without damaging it.

◆

 Never dismantle the stoppers from the final 
roller shutter slat. 

   Otherwise the roller shutter may slip through 

into the roller shutter box and be damaged.

Risk of fatal injury from crushing in the event of 
operation without configured end points.

◆

 The end points must be configured in order to 
ensure safe operation. In order to do so, please 
refer to the corresponding chapter in this manual 
on page 21.

The following installation instructions apply to 
standard installation situations in combination with 
RADEMACHER tubular motors and accessories.
The drive head 

(12)

 of the motor can be installed 

on either the right or left side of the roller shutter 
box. These instructions depict the installation on the 
right-hand side.

7.1  Installation of the tubular motor

Required minimum width for the roller shutter 
box:

Installing the tubular motor at an angle can cause 
the tubular motor or roller shutter to be damaged. 
For example, a roller shutter wound at an angle 
can block the drive and cause damage.

◆

 Always ensure that the tubular motors and bear-
ings are mounted horizontally.

◆

 Please ensure that the winding shaft 

(5)

 and the 

roller shutter 

(17)

 can move down easily and freely 

after installation is complete.

◆

 The roller shutter 

(17)

 may not run over the bear-

ing, the roller capsule 

(4)

 or the drive head 

(12)

during operation.

◆

 Ensure that the winding shaft 

(5)

 and the rigid 

shaft connectors 

(6)

 do not touch the drive (9). 

They may not rub against the tubular motor 

(9)

during operation.

Tubular motor 
type:

Small

Medium

Minimum width 
approx.:

56 cm

67 cm

Incorrect installation can lead to injuries 
(impact injuries and contusions).

◆

 The motor can eject from the drive bearing in the 
event of incorrect installation/fastening. Fasten the 
tubular motor with the securing devices provided.

For automatically actuated awnings:

◆

 A minimum gap of 0.4 m to other parts in the 
area must be maintained when the awning is fully 
extended.

◆

 Awnings used in an awning system must maintain 
a minimum height of 1.8 m.

Incorrectly dimensioned drives and counter 
bearings can cause the roller shutter system to 
be damaged.

◆

 Only use original bearings supplied by the manu-
facturer. Third-party drives and counter bearings 
must be selected in accordance with the torque 
specifications of the respective tubular motors.