RADEMACHER RolloTube CLIS, Translation Of The Original Operating And Assembly Manual

5

EN

3.1  Intended use / operational conditions

Only use the tubular motors for opening and closing 
standard flat roller shutters and awnings.

The use of the wrong tubular motors or compo-
nents can lead to property damage.

◆

The motor cable must therefore be fitted with a 
suitable empty tube up to the respective junction 
box under observation of local electrical regula-
tions, if installed outside.

◆

Only use the manufacturer’s original parts and 
accessories.

◆

Only use tubular motors which correspond to 
the local conditions in terms of their power.  
Incorrectly dimensioned tubular motors can lead 
to damage:

> An insufficiently dimensioned tubular motor 

can be damaged due to overloading.

> An excessively dimensioned tubular motor 

can, 
for example, cause damage to the roller shut-
ter or roller shutter box in self-learning mode.

◆

 Consult a specialist dealer when selecting a 
tubular motor and observe the corresponding 
tractive force specifications on our website: 

www.rademacher.de

Operating conditions

◆

A 230 V / 50 Hz power supply, together with a 
site-provided isolating device (fuse) must be per-
manently available for the electrical connection at 
the installation location.

◆

 The roller shutter must run up and down smoothly. 
It should not jam.

Operational conditions for the self-learning 
mode and for the correct functioning of the 
blockage detection.

◆

The roller shutter must be mounted to the wind-
ing shaft with rigid shaft connectors 

(6)

, see page 

16.

◆

The roller shutter must be fitted with stoppers or 
an end-rail, see page 16.

3.2  Improper use

Using the RolloTube C-line for purposes other than 
previously mentioned is impermissible.

Never use the tubular motor in systems with in-
creased safety-relevant requirements or where 
there is an increased risk of accidents. 

◆

Such applications require additional safety equip-
ment. Observe the respective statutory regulations 
for the installation of such systems.

Never use the tubular motor in continuous opera-
tion. Doing so will cause serious damage.

Never use the tubular motor for shutters with 
openings of ≥ 50 mm in diameter.

3.3  Required expert knowledge of the installer

The installation, electrical connection and main-
tenance must be carried out by a qualified person 
with appropriate training or by a specialist roller 
shutter firm in accordance with the instructions in 
this manual.

i

i

i