99
EN
External control via two inputs E1 and E2
The Troll Comfort DuoFern features two configurable inputs E1 and E2
(230 V / 50 Hz) for connecting external signal transducers (e.g. Venetian
blind switches or Venetian blind buttons / environmental sensors etc.).
The following configurations are possible:
[ 0 ]
Off
[ 1 ]
UP (roller shutter mode)
[ 2 ]
DOWN (roller shutter mode)
[ 3 ]
UP (Venetian blind mode)
[ 4 ]
DOWN (Venetian blind mode)
[ 5 ]
UP / Stop / Down
[ 6 ]
Automatic mode on/off (closer, NO)
[ 7 ]
Automatic mode on/off (opener, NC)
[ 8 ]
External wind signal, NO
[ 9 ]
External rain signal, NO
i
If manual mode is active, the inputs are not taken into
consideration by the controller (except in the case of the
wind function).
i
Both inputs can be configured independently of
each other.
27.6 Menu 9.8.6 - Configuring the inputs E1 / E2
