1. Place the nipple of the suction cups
in the large hole of the bracket and
pull the suction cup into the small
hole to secure them. Push the
rubber damper into the hole in the
middle of the bracket.
3. Insert the windshield mount into the
slot at the front of the detector until
it is locked in position.
4. Plug the small end of the power cable into the detector (located on the left side) and the large end
into your vehicle’s 12V ACC socket.
5. To remove Radenso Pro-M from the windshield press the release button on top of the unit and slide
the unit off the mount.
2. Attach the windshield mount to the desired area of the windshield. Make sure it is in a level position
parallel to the road ahead. To adjust the angle if necessary, gently push or pull on the bracket to bend
it. DO NOT use the detector to bend the bracket.
For firm and secure adhesion to the windshield, clean the windshield and suction cups before usar
installing.
The Radenso Pro-M windshield mount allows a firm and secure installation of the radar detector at
the windshield of your vehicle. Locate an area at the windshield that enables an unobtrusive installa-
tion with clear view to the road ahead.
Rubber Damper
