Radar Detector Radenso RC-M
D
) SPEAKER
Signaling speaker should be placed somewhere in the leg-space of the driver, or passenger.
Youneed to pace it so that when the speaker goes off you can clearly hear the alerts
E) R
ADAR ANTENNA HD+ / HDM+
The antenna captures signals emitted by radars; the choice of the installation place is, therefore,
crucial to its proper functioning and good sensitivity of the detector. The antenna is mounted to
the front of the car, usually into its plastic bumper or behind the front grille in front of the vehicle
radiator. It must be installed in the place from where the front part has a good view of the road
ahead. It is ideal to locate the antenna into the bumper vent, 30-50 cm above the ground. If you
choose to mount the antenna so that the bumper covers its front part, check the material from
which the bumper is made and whether it contains a metal reinforcement. Some types of plastic
can weaken radar waves and reduce the efficiency of the detector. Never mount the antenna
behind metal parts of the vehicle! When installing the antenna, you can use self-tapping screws
in places where the nut can be attached from the other side, as well as classic nut bolts.After
selecting a suitable location for the antenna and the type of screws, drill two to four screw holes.
It is recommended that the antenna is attached with 4 screws. The antenna cable can be slightly
bent. Firstly, attach the antenna with two screws crosswise against each other and tighten them
partly; then mount the remaining two screws.
In some vehicles, it is advisable to carry out the installation using a special support plate that is
included in the sales package. It has the shape of the letter “L” and is made of thick steel plate
with pre-drilled holes. Firstly, screw the support plate to the appropriate place, and then attach
the antenna to the plate.
