A P P E N D I C E S
Series 8000™ O&M Manual
169
Figure 4-2
The Home screen displays fault messages, which are listed
in section 5.3 “Fault Messages & Causes.” To enable or
disable
audible
fault alerts, see
Figure 3-7
. ..................................46
Figure 4-3
Quit the ACU software, or Shut Down
both
the ACU and
the OS. .............................................................................................48
Figure 4-4
Home > Target ................................................................................50
Figure 4-5
Which input fields are displayed depends on the selected
mode. ..............................................................................................51
Figure 4-6
A satellite’s name can be any unambiguous label useful at
the earth station (except TLE and IESS target names,
which are pre-defined). ..................................................................52
Figure 4-7
Operator-defined targets are in the list at Home > Target. ............53
Figure 4-8
The characteristics of targets can be edited. ..................................55
Figure 4-9
Settings for pointing by
look angles
. See section 4.6.4.2,
“Using Bias Angles for TLE and IESS–412.”
.....................................56
Figure 4-10
Settings for pointing by
longitude
...................................................57
Figure 4-11
After choosing a TLE mode, a drop-down list shows all TLE
targets
that are
within the
antenna’s range
. ..................................58
Figure 4-12
Edit a TLE target’s settings to make any site
-specific
adjustments. ...................................................................................59
Figure 4-13
An operator must confirm before the antenna will change
to a different target. .......................................................................60
Figure 4-14
Setting the mode to IESS-412 lists the Intelsat spacecraft
that are
within range of the antenna’s
limit switches and
settings.
...........................................................................................61
Figure 4-15
Settings for TLE (SGP4) or IESS-412 mode. Bias angles can
be saved to more easily re-peak any target for which a
pointing mode
(i.e., not tracking) is used (see section
4.6.4.2).
Default, if unknown: 0°
.....................................................62
Figure 4-16
In pointing modes, you may save peak adjustments as
bias angles
that will reload when the same target is
tracked again in the future. ............................................................65
