T Y P I C A L O P E R A T I O N S
52
Series 8000™ O&M Manual
4.
Unless
you’re
using TLE
or IESS data
(section 4,
tap Apply to save the new bias angles for that target, for use
when it is acquired again later.
TLE/Steptrack and IESS/Steptrack
)
,
tap the “Target name”
field to assign a unique name to the satellite, then tap OK. (The
name can be edited any time.)
Figure 4-6
A satellite’s name can be any unambiguous label useful at the earth
station (except TLE and IESS target names, which are pre-defined).
6.
After selecting the Mode (discussed in sections 4.6 and 4.7), the
other fields requiring operator input change accordingly. Enter
any parameters required by the
new target’s
mode, then tap the
Save button.
Tip
Tap “Shift” to toggle
between upper-case-
with-numerals and
lower-case-with-
symbols.
