Once the last day (Day 7) has been set,
press “+” button to end the program
sequence.
END will appear on the display. A further
pression of “+” button will allow you to
confirm the adjusted program.
“OK will appear on the display for 5
second, confirming that the Program
sequence
has
been
carried
out
successfully.
System is now set to adjust the
temperature according to the new
adjustment of program P1.
Note:
it is possible to exit any time from
the
program
sequence,
without
displaying every hour until Day 7.
To do so, just hol
d “F” button and press “-
“ button.
N.B.:
-
You can abort the display/modification sequence anytime, deleting any settings that have not been saved, just by
pressing “Stand-By” button;
-
Restoring the default settings will delete every P1 Program previously created (see paragraph 6.3);
-
If no button is pressed within 90 sec. during the Program setting process, the result will be the cancellation of the
display/modification procedure and will restore back the factory default settings;
-
During the programmation process, the heating elements will automatically switch to Stand-by mode, and the
radiator does not heat.
EXAMPLE: HOW TO SET A CUSTOM PROGRAM
Let’s see how to program a brand-new radiator, and anticipate the change from ECO to COMFORT temperature one hour
earlier (06:00 a.m. is the default factory settings), for each day from Monday to Friday.
Press “M” to select Program P1
Set the current day of the week (first use
of the radiator) using “+” or “-“ button.
Pre
ss “M” and set the current Hour (first
use of the radiator) using “+” or “-“ button.
Press “M” and set the current Minutes
(first use of the radiator) using “+” or “-“
button.
Summary of Contents for ICON 10
Page 103: ......
Page 104: ...ISICO002_R2...
