TECHNICAL DATA SHEET
3 / 3
STRAIGHT PLUG SOLDER TYPE
R222.L80.010
CABLE .085
Series : SMP LOCK
Issue : 1229 A
In the effort to improve our products, we reserve the right to make changes judged to
be necessary.
COMPONENTS
1
4
2
5
Sub-assembly Insulator/center
contact
Body
Insert the cable into the clamp element.
Present the pointer in front of the clamp element.
Push the cable until it stops, while holding the clamp
element pushed on the hollow part of the pointer.
Turn the clamp element until the release of the pointer.
Present the cutting element in front of the clamp
element.
Push and turn both elements, back part opposite to
the front part.
Once they reach the stop, pull without revolving.
After cooling, remove the assembly from the jig.
After cooling, remove the assembly from the jig.
Put the connector in position unlocked on the
positioner
Slide the cable into the connector until it
bottoms against the soldering fixture.
Tighten.
Put three rings of solder around
the cable and solder.
1
2
4
1
2
Clamp element
3
2
4 (solder)
Pointer
Cutting element
3
3
a
We recommend a cable thermal preconditioning before assembly
3
Mount the positioner A.
Slide the center contact into the positioner A.
Insert the solder gauge between the sub-assembly
insulator/center contact and the cable.The gap must be of
0.1 mm
Tighten.Solder the center contact.
2
4
5
3
1
- Positioner A
3
If necessary trim the inner of the cable with the
pointer Gauge.
1
