Radiant Optics HotZone 1500W Installation Instructions Download

Page: 3 / 4

Revision 092019

Radiant Optics Mfg., LLC (425) 806-3990

5. Attach the power supply leads to

the element leads using the
original screws and nuts.

Ensure the use of high-
temperature (rated >900

hardware if replacements are
required.

6. Re-attach the heater cover. Two

of the screws should go through
the element bracket holes to
secure the element in place.

S1 Single Tab Housing Design: Follow

these steps if the housing has only
one tab

Bend the bracket tabs down

Single tab

Disconnect

Steps S1

–

S4 for single tab housing design

Summary of Contents for HotZone 1500W

Page 1: ...me or inconvenience loss of use of or damage to the original heater and other consequential damages Repair or replacement will be at the sole discretion of Radiant Optics Mfg LLC This warranty constit...

Page 2: ...adiant Optics Hotzone Heater to expose the old element 3 Skip to steps S1 S4 if there is only one tab on the housing Unscrew the element leads from the power supply leads Remove old element and discar...

Page 3: ...gh temperature rated 900o F hardware if replacements are required 6 Re attach the heater cover Two of the screws should go through the element bracket holes to secure the element in place S1 Single Ta...

Page 4: ...e new element so that the bracket tabs hang over the housing attachment holes Secure the bracket to the housing using the previously removed screws Reconnect the power supply leads and the element lea...