Heaters are not to be placed below an electrical convenience receptacle. To
reduce the risk of fire, do not store or use gasoline or other flammable vapors in
the vicinity of the heater.
CAUTION - High temperature, risk of fire, keep electrical cords,
drapery, furnishings, and other combustibles at least 3 feet (0.9 m)
from the front of the heater and away from the side and rear.
For supply connections use wires suitable for at least 194° F (90° C). Grounding is
required for each heater. Remove all construction debris (plaster, sawdust, etc.)
from interior and exterior of the heater. Do not install heaters against paperboard
or low density materials.
Wiring procedures and connections shall be in accordance with the national and
local codes having jurisdiction. Heaters are wired directly to the electrical main.
Junction boxes are not required except as indicated by local code or inspection
requirements. Install on studs or finished wall. Do not install less than 6 feet (1.8
m) from the floor and closer than 6 inches (152.4 mm) from vertical or horizontal
surfaces.
1. Locate and level mounting brackets on studs or finished wall, taking into ac-
count the minimum clearances from vertical and horizontal surfaces.
2. Lay heating unit face down on a solid and protective surface to prevent
scratching. Remove wire channel from rear of heater. Determine which knock-
out will be used for electrical mains and knock the plug out.
3. Hang the bottom edge of the heater on the bottom ends of the mounting
brackets using the narrow slots in the edge of the heater. Do not use the wide
slots for mounting.
4. Thread the electrical mains through the hole in the raceway.
5. Attach the grounding wire to the grounding screw inside the raceway.
6. Connect mains to heater lead wires according to code. Check tightness of all
electrical connections and wire nuts. Inspect all connections for short circuit.
7. Reattach raceway channel to rear of heater.
8. Attach end caps to heater
9. Swing heater up and gently snap the top flanges into the top edge of the heater.
10. Fasten heater to brackets by driving screw through the pre-drilled holes.
INSTALLATION INSTRUCTIONS
