P1520 User Guide
Version 1.2
8
04/02/07
2.
Installing the P1520
Follow these steps to install a P1520 unit:
1.
Place the P1520 with stand in a point of sale area (storefront).
The unit will come completely assembled with tilt stand, touch screen, and customer display (optional)
attached.
2.
The power cord should already be attached to the bottom of the terminal. If not, tilt the terminal to the
side and attach the power cord to the bottom of
the terminal.
3.
If available, route power cable through the
power cord hook
to prevent accidental
disconnects.
4.
Connect the peripheral devices to the
appropriate ports (see connectivity diagram
below)
5.
Connect the network cable to the network port.
6.
Open the Cable Management System.
7.
Route the cables from the terminal connectors
through the Cable Management System and
then down between through the center slot in the plastic base.
8.
Connect the power cable to power connector.
¾
Note: The socket-outlet shall be installed near the equipment and shall be easily accessible.
9.
The P1520 should boot automatically.
With Radiant Application Software:
Upon the initial boot of the P1520, typically the Back Office server
should detect the new P1520 and send all appropriate data files to the unit. After the initial file transfer has
completed, the unit will automatically reboot. Following the reboot the P1520 unit should be fully operational.
With Third Party Application Software:
The P1520 will boot to the operating system or directly to the third
party application.
Cable Restraint:
The P1520 includes a cable management system with cable strap to prevent accidental
disconnects and tampering. The strap is opened, peripheral connections are made, the strap is closed, and then
cables are then routed thorough the slot in the base.
Footprint:
An area of no less than 16.8” inches square is necessary to properly install a P1520 unit with MSR.
This will accommodate the unit as well as its associated mounting hardware and customer display.
Power:
P1520 has an auto-sensing power supply rated for 110V and 240V, 50Hz or 60Hz located in the base.
Source power is drawn from a regular AC wall outlet. The electronics are “universal” – that is, they will
function when connected to standard wall outlets of most nationalities around the world. For use in locales
other than North America, special wall outlet adapters or cables will be required. For international
configurations of the P1520, typically the country specific power cord is ordered separately.
Moisture:
P1520 terminals should not be installed in areas where they might be exposed to direct water spray.
P1520 units are not meant for outdoor installation.
Touch Screen Cleaning:
Any standard glass cleaner that is not ammonia based or water can be used to clean
the touchscreen. Always spray the glass cleaner on the cloth or towel and then clean the touchscreen to prevent
cleaner from running down the glass and gathering on the front bezel.
Power cord hook