P1520 User Guide
Version 1.2
21
04/02/07
6. Remove the hard drive and replace with new hard drive.
7. Screw the 2 phillips screws, which secure the hard drive, into the can.
8. Reconnect the hard drive power and hard drive data connections.
9. Replace back panel and secure with 2 phillips screws
Replacing a Customer Display
The below section describes how to upgrade or replace a customer display.
1. Power down unit via software or On/Off button
2. Important:
UNPLUG power cord from wall or terminal
3. Disconnect customer display cable from terminal connection at bottom of terminal (see Figure 2-1)
4. Unscrew 2 phillips screws from top cover while holding the customer display so that it doesn’t fall
5. Gently pull customer display module and top door assembly from the terminal
6. Disconnect the cable from customer display module and attach to replacement display module. If a
new cable is included with replacement module, use the new cable.
7. Route the cable through the plastic cable restraints on the back of each display and through the top
door.
8. Re-attach the customer display and top door module to terminal.
9. Screw the 2 phillips screws into the top cover to secure it.
Top cover.
2 screws to
remove.
Cable
routing for
2x20 display
Cable routing
for DV OCD
display