Troubleshooting
Knobs and buttons do not respond.
Make sure you have selected Manual mode. Just
touch the [SHIFT / MANUAL] button. The LED to
the right of this button should now light green. The
same state is reached when you turn the device o
ff
and on again, because the DELTA CEP A basically
always starts in manual mode.
BP and HP button in the filter section do not
respond.
You have selected the 24dB lowpass filter. Since
this filter provides only one low-pass, the other two
buttons are not active. Use [SHIFT] & [DIG12dB] or
[SHIFT] & [ANA12dB] to select one of the
multimode filters. These provide as usual the switch
between low pass, bandpass and high pass. If you
activate low-pass and high-pass at the same time
and turn back the resonance, you can also create
great notch filter e
ff
ects.
You play a tone, but the sound generation
remains silent, even though the VCA and the
VCO level control are adjusted.
Take a look at the VCA. Is the VCA EG/GATE LED
lit? If not, the setting probably prevent the VCA from
letting the signal through. Press the [EG / GATE] key
in the VCA section once or twice to assign the
envelope or gate signal to the VCA. In both cases,
the LED lights up.
I hold the [SHIFT / MANUAL] button and
suddenly find the unit in a completely different
mode.
The [SHIFT] key allows you to call alternate
parameters of knobs and buttons. The parameters
that can be accessed using the [SHIFT] key are
printed on the front panel on blue labels. If you hold
down the [SHIFT] key without turning a knob or
pressing a button, you may load the Utility menu.
Just look at the LED chain on the left, if you hold
down the [SHIFT] key. You will see that all blue
LEDs 1-8 are turned on one after the other. When
you release the button, the LED to the right of the
[SHIFT] button will not turn green because you have
landed in the Utility menu. No panic. Touch the
[SHIFT] key to exit this mode.
When I switch from a preset to manual mode to
edit parameters, the current sound suddenly
sounds quite different.
Each preset consists of up to eight snapshots,
which may sound completely di
ff
erent. To edit a
sound, you must first select the desired snapshot.
In manual mode, hold down the [SHIFT] key and
load a snapshot by selecting it with the big knob
and then releasing the shift key. Now you can edit
this snapshot in the value fetch mode.
While in patch mode, the potentiometers and
buttons on the surface do nothing.
That's because each preset consists of up to 8
snapshots. On which snapshot should the pots
a
ff
ect when you start to turn the knobs in patch
select mode?
I use the MORPH mode and would now like to
change parameters during an LFO morph
animation.
Use the control voltage inputs for real-time sound
changes during a snapshot animation. Please note
that some of the control voltage inputs are
equipped with the option to set the modulation
depth. If the modulation depths are turned to 0 in
the snapshots used, the control voltage inputs will
of course do nothing.
von
17
63
Summary of Contents for DELTA CEP A
Page 1: ...Owner s Manual DELTA CEP A...
