RB8762CJF Designer’s Guide (RRD2Z50‐20190314001‐A09‐C2)
38
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit acceptor tout brouillage
radioelectrique subi, meme si le brouillage est susceptible d’en compromettre le fonctionnement.
NCC:
取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻
率、加大功率或變更原設計之特性及功能。低功率射頻器材之使用不得影響飛航安全
及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使
用。前述合法通信，指依電信管理法規定作業之無線電通信。低功率射頻器材須忍受
合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
安裝該模組之主體裝置或設備上必須標示『內含發射器
模組：
FCC:
RF exposure warning
This equipment must be installed and operated in accordance with provided instructions and the antenna(s)
used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons
and must not be co‐located or operating in conjunction with any other antenna or transmitter. End‐users and
installers must be provide with antenna installation instructions and transmitter
operating conditions for
satisfying RF exposure compliance. The final end product must be labeled in a visible area with the
following: "Contains FCC ID: K7T‐RB8762C and "Contains IC: 2377A‐RB8762C “
OEM Integration Instructions
：
This device is intended only for OEM integrators under the following conditions
：
The module can be used to installation in other host. The antenna(s) used for this transmitter must be
installed to the provided separation distance of at least 20cm from all persons and must not be co‐located or
operating in conjunction with any other antenna or transmitter. The module shall be only used with the
integral antenna(s) that has been originally tested and certified with this module.
As long as 3 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end‐product for any additional compliance
requirement with this module installed (for example, digital device emission, PC peripheral requirements,
etc.)
IC:
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio
frequency exposure limits. The Wireless Device should be used in such a manner such that
the potential for human contact during normal operation is minimized.
