91
Radijator Inženjering d.o.o, 36000 Kraljevo, Živojina Lazića - Solunca br.6, Srbija
tel. +381 36 399 140, fax. +381 36 399 150, http://www.radijator.rs
e-mail: radijator@radijator.rs
NOTE : These are the values measured during certification.
•
The room thermocouple (thermostat) can be connected to automation system. In this case,
it is important to adjust the room temperature, which is the main parameter for the
operation of the boiler
BIO
lux
UNI 20
and water temperature in boiler (70
˚
C). When
the room thermostat is activated, the boiler has the first need to reach the room
temperature, under the condition that it is limited by adjusted degree of water temperature
in it. There is a possibility that the boiler stops working before the adjusted temperature
of the room thermostat, in this case the set temperature of the water in the boiler should
be raised, Example to: 70
˚
C.
Warning: Be sure to make the analysis of the flue gases after the finish of installation of the
boiler. Measure the percentage of oxygen (O2).
