68
Radijator Inženjering d.o.o, 36000 Kraljevo, Živojina Lazića - Solunca br.6, Srbija
tel. +381 36 399 140, fax. +381 36 399 150, http://www.radijator.rs
e-mail: radijator@radijator.rs
Picture 26. The positional representation of the cable grommet, main switch as well as the safety
thermostat
STEP 5:
Start the dosing system so that the first pellet grains can fall into the combustion
cup.
(This procedure can only be performed if the automatic controls are in OFF mode
(picture 17 system status))
Procedure:
Press the
P3
key
, and then, by pressing
P4 or P6
keys
in the sub-menu, you
get to the LOAD function, confirm by pressing the
P3
key
, by pressing keys
P4 or P6
switch from OFF to ON, confirm with the
P3
key
. By confirming with the
key, the doser initiates until the first pellet grains don’t start falling into the combustion cup.
Subsequently, by pressing
P4 or P6
keys
you are taken from ON to OFF, confirm by
the
P3
key
. At that moment, the doser stops working. By pressing the
P1
key
exit
the sub-menu.
Picture 27. The representation of the display upon selecting the LOAD function
