6
Installation and Setup
The basic assumption of this manual concerning using the SAC-2K/2.2 in Logic Control mode is that you have already
connected, set up and installed the SAC-2K or SAC 2.2. You can use either the MIDI or the USB connection, the
functionality is the same. Once the SAC is connected to your system, Logic Audio Platinum (version 5.1 or better) will
“recognize” the SAC automatically as a Logic Control and activate the SAC’s LGC operation mode. When you start up
Logic Audio it scans all active MIDI Ports for hardware controllers. This Scan Function sends a brief Sysex message, the
Logic Control responds to if connected. Once the SAC receives this Sysex message, it automatically switches to Logic
Control Mode and waits for your input.
To verify the installataion or to edit the configuration parameters proceed as follows:
Select “Options” > “Control Surfaces” > “Setup…”
This will open up the Logic Control setup window. If you don’t see an icon of the Logic Control in this window, Logic
for some reason has not recognized the SAC. In this case, check your connections between SAC and computer once
more, switch the LGC mode manually in the system menu of the SAC and restart Logic. By now you should definitely see
the following display in the setup window:
