59
SPECTRALIS
Waveform-Modulation
1.) Push the
[Osc Wave]
encoder button in the oscillator section
2.) Depending on the desired oscillator push the
[VCO-Shape]
encoder button under
the display. You should see the following display message:
1/2: VCO1 Wave
´`Shape:100´`Pwm:-1 Sync:0
3.) Push the
[Shape]
encoder button in this menu. You should see the following, already
familiar display message.
VCO1 Waveform Modulation
Src1:None Dph:0 Src2:None Dph2:0
Time-Linearity-Modulation
1.) Push the
[OSC Wave]
encoder button in the oscillator section
2.} Depending on which oscillator is selected push the
[Shape]
encoder button under
the display. You should see the following display-message:
1/2: VCO1 Wave
´`Shape:100´`Pwm:-1 Sync:0
3.) Push the
[PWM]
encoder button in this menu. You should now see the following,
already somewhat familiar display message:
VCO1 TLM Modulation
Src1:None Dph:0 Src2:None Dph2:0
VCO pitch-modulation
1.) push the
[OscDetune]
encoder button. You should see the following menu:
1/4:VCO Fine
´`Osc1:0 ´`Osc2:0 ´`Osc3:0 ´`Osc4:0
Now push the Oscillator finetune encoder buttonof your choice. The following fuction is
available for each of the Oscillators:
1/12:VCO1 Fine Tune Modulation
KeyPt:0 RndPt:0 VibSp:0
These parameters have not been activated yet at this time.
2.) Pushing the
[Page-Up]
button twice will direct you to the Edit page of the Modulator-
Assignment:
3/12:VCO1 Pitch Modulation
Src1:None Dph:0 Src2:None Dph2:0
"How to...?" - The LFO section of the Analog-Synth
Summary of Contents for Spectralis
Page 1: ...1 SPECTRALIS Spectralis...