79
SPECTRALIS
buttons will indicate the amount of the shift of the trigger points.
[ROT>]
Enables moving the whole sequencer line to the right by one step. Again the numeric
buttons will indicate the amount of the shift.
[0]
Displays the actual value of the shift in steps and additionally enables you to return the
sequence to the original position by pushing this button. Please note, that after a
pattern has been saved the shift of the sequencer line will be memorized as the new
original position. Using encoder
(Seq:L11)
you can directly select another line for
rotation. Not only tonal lines can be rotated but also other parameter lines.
3.6 Target selection
The sequencer lines of the Spectralis can play notes, affect parameters of the Analog
Synth and send MIDI data. In the “Target Selection” menu you can determine which
target you want the sequencer-line to control. The line resulting from your selection will
appear differently depending on the target. Note-lines for each step contain settings for
the note length, pitch, velocity and probability. Pure parameter lines contain settings for
the step envelope, its length and intensity of the envelope-control. MIDI control tracks
have no envelopes. Most of the demo patterns in the Spectralis’ RAM already have
preset step-sequencer targets. These date back to the early design phase of the Spectralis
when targets still remained set. The Spectralis has a total of 32 sequencer-lines, which
should be sufficient even for complex automations. You can generate new sequencer-
lines in the sequencer functions menu. The controller for the sequencer-line selection at
the end of the list has an entry “Create”. If you push the line-selection controller the
Spectralis will create a new sequencer-line and will directly display the menu for Target
Selection for the sequencer-line. The menu can also be accessed via the
[Target]
-button
in the Sequencer-Edit section:
Line Section->Group->Parameter
Seq:L01 Filter Volume FBByp
Line:
Use the first rotary encoder to select the sequencer-line for which you want to determine
the target.
Section:
For better orientation the parameters have been set up in sections. The following
sections are available for the Target selection:
Filter-> Filterbank Parameter
AVCF-> Analog Synth analog filterparameters
AVCO-> Analog Synth oscillator parameter
AVCA-> Analog Synth VCA parameter
ALFO-> Analog Synth LFO parameter
DSYN-> DSP Engine Targets (notelines)
ASYN-> Triggergroup control (notelines)
MIDI-> Notes. Aftertouch or MIDI Controller
Step-sequencer advanced - Target selection
Summary of Contents for Spectralis
Page 1: ...1 SPECTRALIS Spectralis...
