RETRACTED
EXTENDED
Retract servo
Retract gear
Retract gear
6- Retract landing gear Installation
WING TOP-VIEW
Link the servo and retract gear arm with push rod.
Be sure to adjust the stroke so that the landing
gear locks in both up and down position.
With the retract and retract servo in the
retracted position, mark the position where
each of the pushrod will attach to the servo
arm, a small piece of masking tape works
well for this. Cut off the excess length each rod.
Ply gear mount
plate x 2
Gear mount x 2
2mm
Bottom view /Ansicht von unten
ELECTRIC RETRACT
LANDING GEAR
7- Electric retract landing gear / Einziehfahrwerk
RECEIVER
ELECTRIC RETRACT
LANDING GEAR
ON
OFF
GEAR
EXTENDED POSITION
RETRACTED POSITION
2mm
Main landing gear
2mm
3x12mm screw
Gear mount
1
3x20mm
Nylon gear
strap
2mm
2
3x20mm
Ply gear
mount flat
Square
plastic
2mm
3
3x20mm screw
..........8
3x12mm screw
......16
Nylon gear strap
.......4
3x20mm screw
Wing - bottom view
8- Fixed gear / Starres Fahrwerk
4
Square plastic x 2
