13- Aileron servo installation
Plastic control horn
....................2
2x20mm screw
..............4
Connector
......2
Aileron push rod
BOTTOM VIEW
Drill the holes throughout the wing
bolt plat ,
from the top to the bottom
of the wing.
TOP
Connect the aileron extension cord to the
aileron servo and secure with adhesive tape
before install the aileron servo on to the wing.
Adhesive
tape
Do the same way with second aileron servo.
-Switch on the radio (trims centered)
then mount the ailerons servo horn in
neutral position.
-The servo horn should
be perpendicular to
the servo
YES
NO
WING BOTTOM-VIEW
Hinge Line/Control horn Alignment
Depending on the position of the linkage, determine the location
of aileron control horn.
The horn holes must be perfectly aligned with the axis of articulation.
Mark the position of the “foot” of the horn on the aileron. Then, with
the drill, make the 2 holes.
Install the aileron control horn as shown.
......2
..2
AILERON
14- Aileron linkage
2mm screw
BOTTOM
12- Wing bolt flat / Verstarkung
6.5mm
17/64”
RIGHT
WRONG
WING
Aileron pushrod
