!
!
X
Align the mark on
both mounts with
the mark on the
fuselage
Align the crankshaft
of the engine with
the side line
Mark
4mm blind nut
Tail pipe
Side line
In case of four-stroke engine
3x25mm screw
11/64”(4mm)
Silicon tube must
be purchased
separately
4.3mm
11/64
4x20mm screw
PP pipe
A B
Connect to
throttle lever
In case of 4T engine
In case of 2T engine
3 mm
1/8
3 mm
1/8
11
Checking for leaks - block the vents and blow into the
feed - if in doubt submersing the tank in a blow of
water will show up any problems.
Blow
Water
2
Ensure that the fuel tank clunk does not touch the rear of the
fuel tank.
After confirming the direction . Insert this assembly, clunk end
first, into the fuel tank and tighten and screw the fuel tank cap
on firmly.
Carefully install the fuel tank
to ensure that they will not
shift during flight (secure the
fuel tank in place using foam
padding).
12
13
