CG
WARNING ! Securely install the receiver and power
pack, ensuring they will not come loose or rattle during
flight.
Never fly before checking the Cg’s required position.
68mm
15- Control surface
Wing section
Check that each clevis is securely snapped into position.
Check that all servo horn screws are tight.
Charge the transmitter and receiver battery.
RANGE TEST YOUR RADIO
Turn on the radio in your plane. With your plane on the ground, you should be able to walk 30 paces away
from your plane and still have complete control of all functions. If not, do NOT attempt to fly.
Be sure that your batteries are fully charged per the instructions included with your radio
Pre-flight check
2-11/16”
Check the operation and direction of the elevator, rudder, ailerons and throttle:
ELEVATOR
AILERON
RUDDER
Always take off and landing your airplane into the wind.
Adjust the engine always from behind, but never from infront or the sides as rotating propeller may badly injure you.
Do not allow watching people to get too close to a rotating propeller.
Ensure the spinner and propeller are securely attached. Immediately disure defective propeller as well as deformed
spinners.
CAUTIONS FOR SAFETY
Fully extend the transmitter and receiver antenna.
Switch off the transmitter and receiver after landing.
Ensure the airfield is spacious enough.
Do not fly your airplane above people standing around.
WARNING
Do not put in a large-than recommended engine. A bigger engine does not necessarily mean better
performance.
Please do not clean your model with pure alcohol, only use liquid soap with water or use class
cleaner to clean on surface of your model to keep the colour not fade.
