26
Preparation
Note: To exit setup, hold down
P
for at least 3 seconds.
;N?J?D=
;N?J?D=
;N?J?D=
;N?J?D=
appears, then the last-used mode screen.
4. Touch the down arrow.
9E:;ýI;Jý
9E:;ýI;Jý
9E:;ýI;Jý
9E:;ýI;Jý
changes to
I;7H9>
I;7H9>
I;7H9>
I;7H9>
.
Note: If you scroll past
I;7H9>
I;7H9>
I;7H9>
I;7H9>
, touch the up arrow
to return to it.
5. Touch
SELECT
. The last selected mode and its
(default or previously set) code appear.
6. If needed, touch the up arrow (or down) to scroll up
(or down) to the desired device.
7. Point the remote control at the desired device, then
touch
SELECT
. The red light and
—
flash.
If the device does not respond
, continue pointing
the remote control at the desired device and touch
the up (or down) arrow to scroll up (or down) to the
next code in the library. A new code appears, and
the red light and
—
flash.
Repeat this step until you find a working code.
Note: The search is complete when all possible
codes have been tried.
;;;;D:ý 9O9B;ý
D:ý 9O9B;ý
D:ý 9O9B;ý
D:ý 9O9B;ý
appears, then
;N?J?D=
;N?J?D=
;N?J?D=
;N?J?D=
. The remote control exits the program and
returns to the last-used mode.
8. Once you have found a working code, touch
SELECT
.
IK99;II
IK99;II
IK99;II
IK99;II
appears, then
;N?J?D=
;N?J?D=
;N?J?D=
;N?J?D=
, then the
last-used mode screen.
To find a code for another device, repeat Steps 2–8.
PROGRAMMING FAVORITE CHANNEL
SCAN
You can program the remote control to scan up to ten fa-
vorite channels.
Only devices with television tuners can be programmed
for Favorite Channel Scan, including televisions, VCRs,
and cable/satellite receivers. If you select another type
of device (receiver, DVD or CD player, and so on),
?D#
?D#
?D#
?D#
L7B?:
L7B?:
L7B?:
L7B?:
appears. An auxiliary device can be selected as
