Remote Control
Remote Setup
8
REMOTE SETUP
You can use the remote control’s device keys to control the following devices:
TV (television), VCR (Video Cassette Recorder), CBL/SAT (Cable converter or
Satellite/Digital Satellite System receiver) or DVD (Digital Video Device) Player.
The default brands and codes preset in the remote are as follows:
•
RCA TV (0200),
•
RCA SAT receiver (0496),
•
RCA VCR (0817) and
•
RCA DVD player (0450)
To control devices other than the default brands perform the following steps. Skip this
section if you use the default brands.
•
Refer to the Manufacturers Codes on page 26 and write down the codes(s) for
the brand of each device you want to program.
•
Turn on all your home entertainment devices.
PROGRAM SETUP CODES
To set up the remote to control other devices or to change the set up of the default TV
perform the following steps. For this example we will set up the remote to control a
Curtis Mathis TV using manufacturers’ code 0 5 9 1.
1. Press
the
TV
key. The red light blinks one time.
2. Press
the
P
key. The red light blinks two times.
3. Enter
0 5 9 1
using the digit keys. The red light blinks one time for each digit
entered.
4. Press
the
P
key. If the device is in the library the red light will blink three times
indicating acceptance of the code. If the device does not exist, the red light
will not blink on the remote.
Repeat the above steps to program codes into remote to control other devices.
For some combo devices (e.g. TV/VCR, DVD/VCR, etc.), you may need to set up each
device type. Press
TV
key to set up TV and enter manufacturers’ code. Then press the
VCR
key and use the VCR code listed.
