49
Trunk Scanning
•
You may replace any frequency by selecting
the bank and channel, pressing
ENT/PGM
and entering the new frequency.
•
If you make an error in the entry process,
repeatedly press
CL
to erase the incorrect data.
Using Trunk Scanning Scan Delay
Sometimes a user might pause before replying to
a transmission. You can set the scanner to hold on
an ID for 2 seconds to wait for a reply. The scanner
continues to monitor the ID for 2 seconds after
the transmission stops before resuming scanning.
Press
•/DELAY
to turn trunk scanning scan delay
on or off.
DLY
appears when the scan delay is set
to on.
Skipping a Trunked Bank
You can scan conventional frequencies
programmed in the same bank by holding down
S
for about 1 second in Trunk Mode. If there is
no conventional frequency, the scanner scans the
next bank.
Talk Group IDs
Finding Talk Group IDs
Set the scanner to Open Mode to find all the
active talk group IDs within the trunked system.
Once you’ve stored the IDs, set the scanner to
Close Mode so you only hear the IDs you want.
To toggle a bank between Open Mode and Close
Mode, press
FUNC +
•
/DELAY/OPEN/CLOSE
.
T+
appears for Open Mode;
T–
appears for Close Mode.
You can also change the a bank’s mode from the
Set Open/Close menu.
1.
In Scan Mode, press
FUNC +
S
/BANK
to go
to the Select Bank menu.
