P
repa
rat
ion
10
7UKPI
"
8GJKENG
"
$CVVGT[
"
2QYGT
You can power the scanner from a
vehicle’s 12V power source (such
as a cigarette-lighter socket) using
a 9V, 300 mA DC adapter and a
size C Adaptaplug™ adapter
(neither supplied). Both are
available at your local RadioShack
store.
.
.
.
.
To power the scanner using a DC
adapter, attach the Adaptaplug to
the DC adapter so the tip reads
positive (+) and set the adapter's
voltage switch to 9V. Next, insert
the Adaptaplug into the scanner's
PWR DC 9V
jack. Plug the other
end of the DC adapter into your
vehicle's cigarette-lighter socket.
±
%QPPGEVKPI
"
VJG
"
5WRRNKGF
"
#PVGPPC
To attach the supplied flexible
antenna to the antenna jack on top
of your scanner, align the slots
around the antenna's connector
with the tabs on the antenna jack.
Press the antenna down over the
jack and turn the antenna's base
clockwise until it locks into place.
%
100'%6+0)
"
#0
"
1
76&114
"
#
06'00#
The antenna connector on your
scanner makes it easy to use the
scanner with a variety of
antennas, such as an external
mobile antenna or outdoor base
station antenna. Your local
RadioShack store sells a variety of
antennas.
.
"
%#76+10
"
.
"
Always connect the
DC adapter to the
scanner before you
connect it to the
power source. When
you finish, disconnect
the adapter from the
power source before
you disconnect it
from the scanner.
±
"
016'
"
±
"
If you use a cigarette-
lighter power cable
and your vehicle's
engine is running, you
might hear electrical
noise from the engine
while scanning. This
is normal.
20-315.fm Page 10 Wednesday, July 24, 2002 2:27 PM
